FYI, to figure this out you would look at the part that plugs into the wall. there’s a bunch of writing on it. at one point it will say something like " input: 120-240 VAC, output: 15 VDC 0.5 A". that’s true for pretty much all transformer bricks. like if you want to see how much a USB brick will supply it will say on there “5V 2A” or whatever.

meh, yes and no. typical auto desk shenanigans. free for personal use.

yeah, freeCAD is kinda crappy compared to even F360

notion is good, but felt so slow. tried it out for a few months, and then did a hybrid approach with obsidian and wound up favoring and then eventually just porting everything over and fully switching to obsidian. been good.

what? I have never heard this about them. is that possibly if you use their sync service?

There’s a table edit plug in that makes it easy. The gripe I have with it is not being able to right-justify numbers (or maybe I haven’t looked close enough)

Witcher 3 was great with this

Yeah, but instead it’s a laughable description of what shops are in town. No flavor. No directions. Just x y and z are here. Just silly BS